The general heating tariffs always include not only the payment of normative heat consumption, but also the maintenance of the heating systems, as well as the losses in their work. So that you do not have to pay for heating, which is constantly turned off or does not warm enough, it is better to install a heat meter in the apartment. In this case, the cost of the services of the heating system will be adequate to their quality.
Such a counter is mounted on a central heating pipe. In addition, you can put thermal controllers so that heat consumption can be effectively controlled when the batteries are too hot. The heat meter must be registered in the subscriber department of the supplier and then pay in accordance with its indications.
The counter takes into account not only the water consumption, but also the temperature at the entrance and on the exit of the apartment. Thus, real heat consumption is calculated, which is measured by hectalllorias. There were meters that can be connected to a computer and record readings on the Internet.
The cost of the meter with installation is fully paid off for a season with a small in a typical two -room apartment. And the larger the area of the room, the more funds it helps to save. For 12 years of service, saving grows into a solid amount. Verification is carried out every five years.
One counter can be dispensed with if the wiring of central heating pipes in the apartment is horizontal. Otherwise, with vertical wiring, heat meters will have to be put in every room. And although the savings of funds here will be obvious, in this case it is better to install a common counter for the entire entrance. It is also easy to install a single heat meter for the entire apartment building, and the general heat consumption to “spread” between the apartments in accordance with their area. All tenants will respond to this profitable proposal.
Sprinkles are made in the upper part of the vertical bars of the frame, and the beams of the ceilings are upset until the spike is formed at each end. But for such a connection, additional fastening will not be superfluous.
The beams of the ceilings are placed quite close to each other – the distance between them should not exceed the double width of each timber. But attic floors require an attentive attitude, since its own weight of wooden ceilings usually exceeds even the created temporary loads in the intersection by 1 m2.