The use of a thermal gas gun is a very convenient way of quickly heating the room. An economical device that uses an inexpensive liquefied gas as fuel, coupled with the operation of a powerful electric fan, is able to disperse heat on all corners of the building.
Thermal guns
Thus turning through the frozen rooms, where it was impossible, due to the cold, is either working, into a space comfortable and convenient for human life. The use of heat guns for heating warehouse, repair and garage buildings, hangars is justified
The heat guns working on gas are quite effective, they cope with the heating of the half -open rooms.
Where long heating is not required, but it is necessary to catch heat right now – for example, in the conditions of emergency repairs, construction.
Also, guns are also used to accelerate the drying of fresh plaster on construction sites. Thermal guns cannot be unconditionally called autonomously working heating devices, because for power 40 – 250 cotton fan of the dispersal heat flow of heated air, electricity is required. Gas guns are equipped with the necessary control systems.
The working readiness state is given using automatic or piezoelectric ignition. Providing the fuel necessary for the operation of the heat gun is possible both from a permanent gas source and from liquefied gas cylinders. The flame of the gas burned in the installation of the gas is heated by the heat exchanger, which is shown by the persecuted fan with a stream of air, as a result of which the latter is also heated.
The installations of thermal gas guns themselves are compact, mobile and easily move from place to place, but require caution when moving the cylinders.
More powerful gas guns
And, accordingly, there are stationary more powerful guns, which include ceiling gas guns. Stationary thermal guns have the highest flow of thermal power. Modern guns are equipped with thermostats and when a certain, given temperature reaches the room, the gun automatically turns off until the next temperature drops, after which it is turned on.
For those who care about their own safety, there are so -called non -unfinished cylinders of the maximum volume of 33.5 liters. The casing of such gas cylinders is made of polymers – epoxy resins and glass threads, the cylinder is transparent, visually you can control the balance of gas, the production of such cylinders is established in Norway.