If you want to have a beautiful wooden floor, but you do not have enough means or you do not like the moments that are inherent in a natural parquet board, then a laminated flooring can be a great solution to your problem. Laminate is a relatively new class of materials.
Laminate can be laid in 20 minutes and forget about it. This floor covering will subtly be in harmony with the whole situation – furniture, wall decoration, while remaining invisible, not distracting the main attention. The laminated coating consists of 4 components that are interconnected. This coating is resistant to wear and is made of synthetic resins based on aluminum or melamine oxide. This material is associated with the main layer of waterproof woody-fibrous slab, with the lower side of the main standing, the stabilizing substrate is combined, which serves to improve the combination of laminate with the floor. Before laying the laminate, it is necessary to level the floor with a dry screed, polymer or bulk floors. The upper layer of laminate is a continuous transparent coating made of aluminum oxide, which provides protection against spots and damage.
Photo belongs to Sumetho / Freedigitalphotos.
The use of such technologies, as well as the addition of a large amount of synthetic resins to the layer, exposed to wear, made the laminate actually perfect flooring. According to some laminated floors manufacturers – after the introduction of new technologies for their coverage of steel, 10, or even 20 times harder. Since the upper layer is very dense, it is much more difficult to leave the spot on it, scratch, burn, etc. D. In order to avoid any other, more severe damage to the laminated flooring and to extend its service life, some simple recommendations for the care must be observed. Try to clean the dumplings of dirt and dust daily with a vacuum cleaner, wipe the spilled liquids to avoid their laminate seams, spend a slightly damp mop cleaning once a week.
If you damaged the laminated coating, use only laminate coatings to restore minor dents and scratches. Remember that in the room where the laminate is laid, the temperature should be not lower than 18 degrees Celsius.