Surface decoration with drywall sheets is effective, especially when decorating the old bases of dilapidated buildings. Nowadays, few will already be surprised at the complex geometry of surfaces from this material. The reason for the sufficient prevalence of the technology for the decoration of these elements. But how in any type of construction and final work there are its underwater stones. This previously concerns surfing surfaces with samannt origin. So, to determine how the structures are arranged on such a surface, it is necessary to pay attention to the fact that the design under the sheets of drywall is attached on the surface and in the set buildings is not sufficient density for reliable fixation of such. Especially if we are talking about the ceiling part of the structure.
To start finishing, for example, the ceiling part, it is necessary to draw a drawing of the places of the device of each structure of the structure. So, as a rule, for the ceiling part, KNAUF gypsum plasters are selected in its thickness 10 mm, for the wall part of the structure there is a thicker. In this case, the design of the ceiling part differs in the distance of the intermediate profile. Between the profiles of the ceiling decoration, the distance is thirty or forty centimeters, much depends on the area of the finish. In this case, it is required to initially insert the guide profiles, after marking the level of those when fastening.
After the guide profile is repaired to the wall, an intermediate profile is put up. It is required to measure its length so that when inserting it into the guide, he does not burst him and feel free. The distance is measured between them starting from the middle of the profile itself in the middle there is a strip that determines the edge of the drywall sheet when lining. In this case, the profiles on the edges cling to the metal screws (bug) and the structure itself clings to the ceiling with suspensions (one suspension of eighty square centimeters). It is at this stage that there is a difficulty that cannot be found when decorating any other surface.
Since samannt or surfaces of old buildings have a sheathing with wooden rails and beams important to hook the structure for them. Therefore, it is imperative to find these elements of the ceiling, for which many resort to piercing the surface of the location of these wooden elements. Often you have to meet for this reason the dissatisfaction of those who arrange the decoration of such structures, but still reality is as follows, sometimes it is necessary to produce the device of the finishing surface in the structure itself. When mounting suspensions, you often have to shift their fastening place and adjust to wooden rails. In this case, you can install them more often. These are the features of the decoration of samanite buildings. To be continued…